Copperloy Dock Lifts

Manufacturer: Copperloy

F.O.B. Midwest Warehouse

Copperloy Dock Lifts line up a load to any truck bed height with the push of a button. Designed for permanent installation or portable use, their heavy-duty, solid-steel construction and powerful hydraulics handle loads up to 25,000 lbs. safely and efficiently. With up to 60" of vertical travel, a Copperloy dock lift will accommodate even the highest trucks.

Copperloy builds their dock lift for durability, performance and safety!

Features:

  • Designed for long life and dependability
  • Solid-steel scissors provide exceptional stability
  • Pit-mounted units, all rollers are captured to prevent upending
  • All running surfaces have a steel tread plate to for sure footing
  • Long leak-free life with piston-type hydraulic cylinders with hard-chrome plated and polished rods and polyurethane seals and wear plates
  • All pivot pins are turned, ground, polished and hard-chrome plated
  • The pressure compensated hydraulic valves assure smooth starts and stops even with controlled motion


Permanently installed Pit-Mount Dock-Lifts are available in standard capacities from 5,000 lbs. to 25,000 lbs., to accommodate everything from hand carts to power pallet jacks to lift trucks. Higher capacities are also available. Because Pit-Mount lifts are flush with the grade when fully lowered, they are protected from accidental damage caused by careless truck operation.

Surface Mount Dock Lifts make any concrete surface a loading dock. You can have a loading dock anyplace you need one, as long as the roadway surface will support the Dock-Lift base without deflecting. There is NO pit required. Standard models are available with capacities up to 5,000 lbs., adequate to accommodate hand carts, 4-wheel carts and pallet trucks. Heavier capacities are available for special applications. Surface-Mount Dock-Lifts are equipped with optional flip-down wheels for easy transportability to new locations, using a removable dolly handle. Special bridge and ramp plates are available to adapt the Dock-Lift to your application. The approach ramp and end-rails can be factory located to accommodate right-angle loading. The 42" high handrail is removable for awkward loads. The standard self-contained, on-board power unit is designed for operation on 110/220 volt, 1-phase, 60 Hz power so that you can use the Dock-Lift anywhere. Other power options are available.

Rugged Platform Design: The heavy-duty reinforced platform is engineered for minimal deflection while raising and lowering; and positive stop blocks eliminate platform deflection. Standard platform width range from 72" to 96" and standard lengths from 96" to 144", with beveled toeguard edges to meet ANSI safety requirements. The steel tread bridge plate is 12" OAW x 72" OAL, with two (2) chains. The handrails are removable for loading flexibility. U.S. Post Office options are also available.

The standard power unit is configured with a 5HP electric motor for fast raising. The motor is designed to operate on 240/480-volt, 3 phase, 60 HZ power. Consult factory for other electrical options. A one piece aluminum manifold block, solenoid valve, and check valve are located in the remote-mounted power unit to control hydraulic functions.

Electrical components are contained in a NEMA 4 and NEMA 12 enclosures to keep dust and moisture out and fuses protected. DU maintenance-free bearings on all pivot points minimize wear and eliminate the need for greasing. Removable pins simplify removal of cylinders and scissor legs and a maintenance strut is provided to keep Dock-Lift raised during hydraulic servicing.

NOTE: Priced per application.



1 Model Available for
Copperloy Dock Lifts

*Prices subject to change without notice

Products without prices are not available for purchase through our shopping cart
If you are interested in these products, add them to your quote list by clicking the red button below

Model No. Price Ea. Qty
CDL Call for Pricing